Publicité
3
Assembly
3.1
To assemble the product
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Keep the packaging material out of the reach of children
and pets – risk of suffocation
● Do not use the product if any parts are missing or
damaged.
1
Remove all packaging material. Do a check of the
electric radiator, the power cable and plug for
damage.
2
Turn the product upside down and attach the wheel
bracket to the bolts. (Figure 2)
3
Lock the wheel units in place with the wing nuts.
Make sure that the wing nuts are fully tighten and
turn the product up-right. (Figure 3)
4
Operation
4.1
To operate the product
Warning! The product gets hot when in use. Do not
touch hot parts – risk of getting burned.
Warning! Keep the product under careful supervi-
sion when it is used by, or near children or persons with
functional disorders.
● Connect the product to a power outlet.
● The upper part of the control panel is a display for
information, while the lower part contains touch buttons.
Push the icons shown in the control panel to start, set
and stop the product. (Figure 4)
A.
Timer button: to set the timer
B.
Mode Button: to select between the power mode
(low, medium, high)
C.
On/Off button: to start or stop the product or set
to standby mode
D.
"-": to decrease the temperatur and to set the time
in timer mode
E.
"+": to increase the temperatur and to set the time
in timer mode
8
4.2 Start and standby mode
1
Connect the product to an power plug. The buzzer
gives a long audio prompt.
2
Push the the power button to start the product.
3
Push the button again to set the product in standby
mode.
4.3 Mode settings
● Push the mode button (B) to select the power mode: low,
medium or high. (Figure 4)
4.4 To set the temperature
1
Start the product and push the "+" button or "–" to set
the temperature. The temperature will be shown in
the display.
2
Push and hold "+" or "–" to change the value. If no
buttons are pushed for 5 seconds the setting is
automatically saved.
4.5 To set the timer
The timer can be set 0 to 24 hours. The settings increases or
decreases by one hour each time the "+" or "-" button is
pushed.
Note! When the value shown in the display is 0H, push the
"–" button to switch to 24H. When the value shown in the
display is 24H, push the "+" button to switch to 0H.
1
Set the product in standby mode.
2
Push the timer button, push and hold "+" or "–" to
change the value.
3
Set the applicable time and push the on/off button or
the mode button, or wait 5 seconds to start the
product in timer mode.
4.6 To stop the timer
● The timer is deactivated when the set value is 0H.
The timer is activated when the set value is over 0.
1
Set the timer to 0H and push the on/off button or the
mode button or wait 5 seconds to exit the settings
mode.
Note! When the timer is set it can be deactivated by putting
the product in standby mode with the power switch.
Publicité
