Publicité
ATTENTION:
The leaf vacuum/blower is only approved
for leaves and garden debris such as
grass or small branches. It is not allowed
to give it other uses.
Use the machine only in cases that are
explicitly indicated as appropriate use.
Any other use will not be suitable. In case
of improper use, the manufacturer is not
responsible for damages or injuries of any
kind; The person responsible is the user or
operator of the machine.
Keep in mind that our device is not
indicated for commercial, industrial or
workshop use. We will not assume any
type of guarantee when the device is
used in industrial, commercial or workshop
areas, as well as similar activities.
RESIDUAL RISKS Even if this tool is used
properly, there are always residual risks.
Depending on the structure and design
of this power tool, the following risks
may occur:
1. Lung injuries if a protective dust mask is
not used.
2. Hearing damage if proper hearing
protection is not used.
3. Damage to health resulting from
vibrations of the hands and arms if the
device is used for a long period of time, is
not held correctly or if proper
maintenance is not carried out.
REDUCE NOISE EMISSION AND
VIBRATIONS TO A MINIMUM
1. Only use devices in perfect condition.
2. Maintain the appliance and clean it
regularly.
3. Adapt the working mode to the device.
4. Do not overload the device.
5. If necessary, let the device be checked.
6. Turn off the device when not in use.
7. Wear gloves.
ASSEMBLY OF THE SUCTION TUBE
Place the wheels on the front suction tube
as far as they will go and secure with the
long screw (Fig.2).
Join the front suction tube with the rear
one and secure with a short screw (Fig.3).
Next, insert the complete suction tube into
the motor housing and secure with 2 short
screws.
COLLECTION BAG ASSEMBLY
Hook the hook to the suction tube.
Next, place the catch bag over the fitting
on the motor housing and make sure it
clicks into place.
DETERMINE THE LENGTH OF THE BELT
Adjust the length of the belt so that the
suction tube barely reaches the ground.
USE
Connect the device cable with the cable
extension.
To turn on the machine, press and hold
the ON/OFF switch.
To disconnect, release the ON/OFF switch.
Vacuum
T u r n t h e l e v e r ( H ) t o t h e v e r t i c a l p o s i t i o n .
T h i s c a n b e d o n e b o t h w h e n t h e d e v i c e i s
s t o p p e d a n d w h e n i t i s r u n n i n g .
Blow
Turn the lever (H) to the horizontal
position. This can be done both when the
device is stopped and when it is running.
Publicité
