Publicité
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
The defrost cycle will end automatically.
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
•
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
•
Do not place uncovered items as below inside
the appliance, as this can lead to a damaged
and leaking evaporator, and thus void your
warranty: hot food, hot liquids, acidic fluids,
acidic products.
•
Wrap or cover food where possible.
•
Do not obstruct the fans inside the appliance.
•
Avoid opening the doors for prolonged periods
of time.
Lock/Unlock the Doors
•
A lock is fitted to the doors to ensure foodstuffs
are kept secure within your POLAR appliance.
•
Use the keys provided to lock/unlock the door.
Cleaning, Care &
Maintenance
•
Switch off and disconnect from the power
supply before cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
•
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
CZ781_CZ782_CZ783_CZ784_ML_A5_v2_20241104.indb 5
CZ781_CZ782_CZ783_CZ784_ML_A5_v2_20241104.indb 5
Refrigerating tips:
•
•
buttons to display the
•
•
•
Cleaning the Condenser
Periodically cleaning the condenser can extend the
life of the appliance.
POLAR recommend that a POLAR agent or qualified
technician should clean the condenser.
Failure to clean the condenser will increase energy
consumption, reduce the performance and life
of your Polar unit, and thus may invalidate your
warranty.
Condensation and ice will form with frequent
and prolonged opening of the doors.
Operating outside of the recommend
temperature range and placing next to a heat
source will also increase the amount of ice
and internal/external condensation. If external
condensation occurs wipe the surface down
with a cloth.
Excessive ice will result in longer running times
that will increase energy consumption and
increase the deterioration of components.
If the gasket or seal is damaged or deformed,
energy consumption will increase. To restore
efficiency, replace gasket.
Do not obstruct fans and do not exceed
max load lines, as doing so will impact air
distribution and increase energy usage.
EN
5
2024/11/4 15:02
2024/11/4 15:02
Publicité
