Télécharger Imprimer la page

Bosch GHG18V-50 Consignes D'utilisation/De Sécurité page 9

Masquer les pouces Voir aussi pour GHG18V-50:

Publicité

Max Air Flow
Temperature levels
Voltage rating
Allowed ambient temperature
- during charging
- during operation
- during storage
* Achieved with the GBA18V40 and higher capacity (Ah) Bosch Li-Ion battery packs
Please refer to the battery/charger list included with your tool.
The heat gun is intended for removing paint, deforming and welding plastic, and heat shrink-
ing plastic tubes. It is also suitable for general soldering, melting and thawing purposes.
the risk of starting the tool accidentally.
To reduce the risk of injury, do not remove or attach the nozzle accesso-
ries until the tool and the nozzle accessories have cooled to room tem-
perature.
Inserting Battery Pack
With the lock-off button (Fig 1, 4) in the cen-
ter (locked) position, slide the charged bat-
tery pack (9) into the housing until the bat-
tery pack locks into position.
Your tool is equipped with a secondary lock-
ing latch to prevent the battery pack from
completely falling out of the handle, should
it become loose due to vibration.
Releasing Battery Pack
To remove the battery pack:
Press the battery pack release button (Fig. 1,
8) and slide the battery pack (9) completely
out of tool housing.
1600A02E16 GHG18V-50 20211221.indd 9
Specifications
Battery Packs/Chargers
Intended use
Assembly
Disconnect battery pack from tool before making any assembly, adjust-
ments or changing accessories. Such preventive safety measures reduce
6.2 CFM*
570 °F/930 °F (300 °C/500 °C)*
18V
32...113 °F (0...+45 °C)
–4...122 °F (–20...+50 °C)
32...122 °F (0...+50 °C)
Removing Heat Shield
When working in tight spaces, the heat shield
(Fig. 1, 2) can be removed by turning it. To
remove or put on the removeable heat shield
(2), switch the heat gun off and let cool.
Attaching and Removing Nozzles
All nozzles that are available accessories
from Bosch are compatible with Bosch heat
guns.
To attach the nozzle accessory, such as the
reflector nozzle (Fig. 1, 11) or the reduction
nozzle (10), insert between the nozzle (1)
and removable heat shield (2). Push gently to
insert.
To remove, allow the nozzle to cool down to
room temperature, and pull accessory gently
from the nozzle.
-9-
12/21/21 7:52 AM

Publicité

loading