Publicité
Level ground
To ensure proper function, the refrigerator must be placed on a flat, firm and stable surface resting level on four
supports.
Fixing the refrigerator to the cabinetry
The refrigerator can be affixed to the RV cabinetry by installing the screws provided, or a similar Pan Head type where
the shank connects into the backer support by 25mm (1"). Screw into the holes on the inner compartment, as shown
below:
To avoid large stress on the side screws, for rear kitchen applications you must use the top brackets (optional item)
or two #8 or #10 Pan Head type screws (2" long) and secure it to the floor via the hole in the bottom hinge plate. For
sidewall kitchen applications or other installations, it is suggested to use one of the two additional mounting methods.
OPTIONAL: Two additonal brackets are available to secure the top of the refrigerator to the cabinets, along with
hardware screws for attaching to the refrigerator body.
Fixing the shelves in the refrigerator
The glass shelves in the refrigerator compartment are affixed in production for safety considerations.
Door and drawer function
The refrigerator doors function as French style doors, the user can open the door freely on both sides. The freezer is a
bottom drawer that slides out. All doors incorporate a self latching mechanism to retain the doors from opening during
travel. Ensure the latches and handles function properly.
Leveling
Make sure to level your refrigerator using the front leveling feet. If not leveled properly, the refrigerator door gasket's
sealing performance will be affected, or it may even lead to operating failure of your refrigerator.
Power on
After completing the standing time requirement, connect the refrigerator to the dedicated power supply battery in the
RV, then the compressor will start working. Open the freezer door after 1 hour to check operation. If the compartment's
internal temperature drops significantly, it indicates the refrigeration system is working normally.
Holes to fix the refrigerator to
the cabinet.
Note: Center of mounting
hole is 51mm (2") from the
front edge of the refrigerator
cabinet.
- 6 -
CCD-0008955 Rev: 10-07-24
Publicité
