Publicité
Preparation and Installation
Refrigerator Unit Preparation
1. Packaging:
Remove all packaging, including the foam backing at the bottom of refrigerator and the tape fixing accessories in the
box.
2. Standing time:
Place the refrigerator in a proper up-right position for more than one hour before connecting power to ensure
refrigerant settles for normal operation.
3. Cleaning:
Make sure the accessory parts inside the refrigerator are present and the inside is wiped with a soft cloth.
Site Preparation and Installation
Ventilation requirements
The position you select for the refrigerator installation should be well-ventilated with minimal hot air. Do not place your
refrigerator close to a heat source and avoid exposure to direct sunlight to guarantee optimum refrigerator
performance with minimum energy use.
Unobstructed ventilation shall be maintained around the refrigerator or embedded structure.
Heat dissipation space
During operation, the unit gives off heat to surroundings. Ensure that there is adequate space between the refrigerator
and neighboring walls or large objects. A minimum spacing of 25.4mm (1.0") is highly recommended on the top, on
both sides and at the backside of the refrigerator.
Dimensions suggested below:
W
D
23-5/8"
26-3/16"
(600mm)
(665mm)
CCD-0008955 Rev: 10-07-24
H
A
66"
35"
(1676mm)
(888mm)
B
C
37-13/16"
Maximum
(960mm)
1/8" (3mm)
- 5 -
E
F
Minimum 1"
Minimum 1"
(25mm)
(25mm)
G (top)
5/8"
(16mm)
Publicité
