Publicité
7. WARNING - Do not use electrical appliances inside the food storage compartments of the refrigerator unless they are
of the type recommended by the manufacturer.
8. Maintenance - Disconnect the power source from your refrigerator before carrying out user maintenance on it.
9. If a component part is damaged, it must be replaced by the manufacturer, its service agent, or similar qualified persons
to avoid a hazard.
10. Follow local regulations regarding disposal of your refrigerator due to flammable refrigerant and gas. All refrigeration
products contain refrigerants, which under the guidelines of federal law must be removed before disposal. It is the
consumer's responsibility to comply with federal and local regulations when disposing of this product.
11. Do not store explosive substances such as aerosol cans with a flammable propellant in this device.
12. This appliance is intended to be used in a recreational vehicle.
13. When user cannot open the door at one side, please check if the other side of the door is fully closed. Users are only
allowed to open the door when one side is fully closed.
To avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions.
Power Source Requirements
This appliance is a Class III appliance which must only be connected to a 12 Volt power source.
The circuit must be protected properly between the appliance and power supply main, 15A min, 20A max is acceptable.
Do not use auto resetting or minibreaker type circuit protection.
Before using, disconnect the appliance from the main power supply. Wiring connections should be made according to
the wiring diagram.
For normal use, the connection to the power source connection must meet the following requirements:
Wire Size
The Max Length (Feet)
14 AWG
10 Feet
12 AWG
20 Feet
10 AWG
30 Feet
8 AWG
45 Feet
6 AWG
60 Feet
The DC unit is not equipped with a power source. Please purchase a power source from an
authorized dealer.
Remarks
For maximum battery performance ensure the voltage drop between each power source (battery &
converter) and the refrigerator does not exceed 0.4V DC.
Note: Only authorized or qualified professionals should perform repair services for this appliance.
Wire Connection Diagram
1. Connect terminal
with Positive pole of 12V DC.
2. Connect terminal
with Negative pole of 12V DC.
3. If the unit is installed in an RV, the GND terminal
CCD-0008955 Rev: 10-07-24
should be connected directly to the RV chassis.
- 3 -
Publicité
