Publicité
Power Supply Interruption
This refrigerator works on 12V DC power supply (For example, an RV battery). Always estimate the operation time based
on your available battery capacity.
If you are aware of an upcoming power outage:
● Adjust the thermostat knob to the highest setting an hour in advance so that the food will get frozen (do not store
new items at this time). Reset the temperature mode to normal when power returns in a timely manner.
● You can also make ice in a watertight container in advance and use it in the upper part of the freezer to help the
food items stay fresh longer.
The refrigerator is equipped with a battery monitor (Refer to the Functions section for more information). In the event
of an Under Voltage alarm:
● Look for available alternative power sources in the area.
● Check your battery power charging systems for faults. (Example: Solar panel system, distribution panel or converter
In the event of power supply interruption:
● Take care of the frozen food stored in the refrigerator.
● Try not to open the refrigerator door many times to preserve the cold air inside and keep the food fresh longer.
Adjusting the Shelf (Optional)
To avoid the possibility of child entrapment, do not remove any shelf from the refrigerator. Shelving
is intended to prevent children from playing in the compartment area. The shelves are fixed in the
compartments at the factory.
The shelves can be adjusted with the following instructions:
● Open the compartment door.
● Loosen the fixing screw using a Phillips screwdriver.
● Pull to remove the shelf out from its original position.
● Slide the shelf into an appropriate position and fix the shelf locker with the screw.
Maintenance and Cleaning
Do not use hands to clean under the base of the refrigerator to avoid harm from sharp metal edges.
Internal and External Cleaning
Any food residue in the refrigerator is liable to produce bad odors, so the refrigerator must be cleaned regularly. The
refrigerator food compartment should be cleaned at least once a month.
Remove all shelves, crisper, bottle racks, cover board and drawers, etc. and clean them with a soft towel or sponge
dipped in warm water or neutral detergent.
Clear off any dust accumulated on the rear panel and side plates of the refrigerator often.
After using detergent, be sure to rinse it with clean water, and then wipe it dry.
Do not use bristle brush, steel wire brush, detergent, soap power, alkaline detergent, benzene, gasoline,
acid, hot water or any other corrosive or soluble items to clean the cabinet surface, door gasket, plastic
decoration parts, etc. to avoid damage.
Carefully wipe dry the door gasket and clean the groove. Afte cleaning, fix the four corners of the door gasket first and
then embed it segment by segment into the door groove.
Shelf and Crisper Removal
● Refrigerator Shelf - When removing the shelf, lift it up first and then pull it out; when installing the shelf, place it
into position before putting it down. Keep the shelf rear flange upward to prevent food from contacting the liner
wall. When taking out or putting in the shelf, hold it firmly and handle with care to avoid damage.
● Crisper - After using or cleaning the crisper cover, be sure to put it back onto the crisper, so that the internal
temperature of the crisper will not be affected.
- 10 -
CCD-0008955 Rev: 10-07-24
Publicité
