Publicité
6
Ripple Fold Fabric Installation
6.1 Drapery Panel Height
Drapes are typically sized so the bottom of the drapery track and top of the drapery panel are located 4 in (101 mm) above the window
casing. Location may need to be adjusted to accommodate the specific drapery panel height and application. It is recommended that
a space of 1⁄2-1 in (13-25 mm) be maintained between the bottom of drapery panel and the floor.
Drapery
panel
height
+
⁄
-1
⁄
in
3
1
4
4
(19-32 mm)
Bottom of
drapery panel
Floor
6.2 Attach the Drapery Panel
A.
Attach a pendant to each male auxiliary snap on the drape, leaving 3 at
each end open for attachment to the drive/idler snap bracket and / or the
master carrier.
B.
Hang the pendant in the corresponding auxiliary carrier as shown.
C.
Fasten the remaining snaps (3 at each end) to the drive/idler snap
brackets and master carrier(s) according to the drapery configuration,
following the appropriate configuration example below.
NOTE: Master carriers for pull-to-start drapery tracks with ripple fold fabrics
accept female snaps. Non-pull-to-start master carriers accept male snaps.
Mounted Drapery Track
Auxiliary Carrier
Pendant
⁄
-1 in (13-25 mm)
1
2
To Male Snap
on Drape
Sivoia QS Drapery System Installation Guide
⁄
in (13 mm)
1
2
Drapery Track
⁄
in (19 mm)
3
4
Snap Tape
Drapery Panel
Page 7
Publicité
