Publicité
11
The Optional Manual Open Feature
Note: The Manual Open feature is only available in systems that were originally ordered with the option. The following instructions do
not apply to the standard Master Carrier.
NOTE: The Manual Open feature is not available with Pull-to-Start.
11.1 Enabling the Manual Open Feature
The Manual Open feature allows the drapes to be manually opened in the event of a power failure, or if the user is not aware the
drapery track is motorized.
With the drapery closed (the window is covered), grasp the drape near the top and pull in the direction of the open limit (exposing the
window). The Master Carrier Hanger Bar will disengage from the Master Carrier Latch Plate, allowing the drape to open manually. Pull
the drape to the desired open position.
11.2 Returning to Motorized Operation
A.
To re-engage the Master Carrier manually, pull the drape back to the closed position until the Master Carrier Hanger Bar meets,
then engages, the Master Carrier Latch Plate. Motorized operation is restored.
B.
To re-engage the Master Carrier using the drapery drive, double-tap the Open Limit
move to the open limit position and engage the Master Carrier Hanger Bar. Motorized operation is restored.
11.3 Adjusting the Release Mechanism
The release mechanism is adjustable to increase the force required to disengage the drapery from the motorized carrier system.
When heavier fabric panels are installed, adjustment may be needed to prevent the motorized carrier system from disengaging
under the normal operating load. To test and adjust:
A.
With the drapery in the open position (the window is
exposed), double-tap the Close Limit
B.
If the Master Carrier Hanger Bar disengages from the
Latch Plate during travel, increase the tension by fully
tightening Tension Adjustment Screws 1A and 1B.
C.
Double-tap the Open Limit
the drapery, and re-engage the release mechanism,
then repeat step 9.3A to test the new tension
setting.
D.
If the Master Carrier Hanger Bar disengages from
the Latch Plate during travel, increase the tension
by fully tightening Tension Adjustment Screws 2A
and 2B.
E.
Repeat step 11.3C to test the new tension setting.
F.
If the Master Carrier Hanger Bar disengages from the
Latch Plate during travel, maximize the tension by
fully tightening Tension Adjustment Screws 3A and
3B.
button.
button to reopen
Master Carrier
Sivoia QS Drapery System Installation Guide
button. The Master Carrier Latch Plate will
Drapery Track
Master Carrier
Latch Plate
Hanger Bar
VIEW FROM BELOW
3B 2B 1B
Tension Adjustment Screws
(behind the hanger bar)
3A 2A 1A
Tension Adjustment Screws
Page 13
3A
2A
1A
Publicité
