Publicité
8
Ripple Fold | Drapery Tape Assembly (with Pull-to-Start)
The Lutron ripple fold drapery system is compatible with standard ripple fold snap tape with spacing of 4.25 in (108 mm) between
snaps.
• Standard carriers accept male snaps; quantity required varies with track width.
• Three (3) female snaps are required at the draw end as shown.
– Compatible female snap tape is available from Alan Richard Textiles, Ltd.
By the yard:
alanrichardtextiles.com/store/DRFT02-Y.html
By 100 yard (91.4 m) roll:
• Single-draw configurations require one drapery panel.
• Center-draw configurations require 2 drapery panels
– Butt-closure: snap layout shown below mirrored on the second panel.
– Overlap-closure: the draw and return end snap layouts shown below are mirrored on the second panel, and the right panel requires
one more auxiliary snap than the left. (See the Overlap-Closure diagram on previous page.)
C
B
A
Return
0.125 in
(3 mm)
alanrichardtextiles.com/store/DRFT02.html
A
A
Edge Sew Detail
Male
Snaps
Top edge
of fabric
Snap Tape
Edge Sew Detail
A = Standard ripple fold snap tape spacing of 4.25 in (108 mm)
B = 1 in (25 mm) for one-way draw, butt-closure, and overlap-closure
master carriers
2.25 in (57 mm) for the extended overlap-closure master carrier
C = Varies with return distance
D = 0.75 in (19 mm)
Sivoia QS Drapery System Installation Guide
A
DRAPERY PANEL
* NOTE: Users will pull on the drapery,
putting a load on the female snaps. Use
Tex 40 thread or stronger to attach the
tape to the fabric.
A
A
*
Female
Snaps *
Draw
Page 11
B
D
Publicité
