Technical Data; Declaration Of Conformity - HAEGER HELI FAN Mode D'emploi

The fan oscillates
1. Check the blades are securely fastened to the holders.
2. Check the blade holders are tight on the motor.
3. Ensure the mounting bracket is properly screws to the ceiling.
4. Most fan oscillation problems are caused by uneven blade levels. Check this
level by choosing a point on the ceiling above the end of one of the blades.
Measure this distance. Keeping the measurement within 3mm, rotate the
fan until the next blade is positioned for measurement. Repeat for each
blade. To set a blade end down, insert a washer (not supplied) between the
blade and the blade holder to the screw closest to the motor. To adjust one
blade, end up, insert a washer (not supplied) between the blade and the
blade holder to the two screws farthest from the motor.
5. If the blade oscillations are still visible, exchange two adjacent blades to
redistribute the weight and possibly cause smooth operation.

Technical Data

Models:........................................................... FC-563.004A
Rated voltage range: .................................... 220-240V~50Hz
Rated power: ................................................. 70W
Motor insulation class: .................................... E (120˚ C)
Protection index: ............................................ IP20
Recommended surface area: ...................... 18~20 m
Motor net weight: .......................................... 2.4kg
Blade size: ...................................................... 610 x 123 x 0.9mm
Running in 5 speed: ....................................... 135 / 170 / 200 / 240 / 300 rpm
Fan sound power level: ................................. 58.1 dB(A)
Maximum fan flow rate: ................................ 217.62 m
Service value: ................................................ 3.51 (m
Maximum air velocity: ................................... 3.45 meters/sec
Measurement standard for service value: .... IEC60879:1986+ (corr.1992)

Declaration of Conformity

This product has been tested and produced according to all relevant current CE
guidelines, such as:
-
-
-
and has been constructed in accordance with the latest safety regulations.
The CE mark attests this product with all relevant directives.
Instructions for use
electromagnetic compatibility Directive 2014/30/EU,
Low voltage Directive (LVD) Directive 2014/35/EU,
RoHS with its amendments Directive 2011/65/EU,
2
/min
3
/min)/W
3
English
9