Technical Data - HAEGER New Tornado Mode D'emploi

English
Cleaning
Clean the surface of your fan with a dry cloth if it is covered by dust.
•
Usually pay attention to the operation. If the blade doesn't rotate freely or, it
•
sounds any in normal noise, please refer to your supplier!
Use a vacuum-cleaner to suck out the dust of the blade, the grilles and the
•
inner parts.
Important Note:
Do keep your fan disconnected to the electricity before doing any
maintenance!
Warning
• If you need to remove the safety guard: always switch the device off
and remove the mains plug.
• Under no circumstances should you immerse the device in water for
cleaning purposes. Otherwise this might result in an electric shock or
fire.
• Clean the outside of the device with a dry cloth without any
additives.
• If the device is very dirty wet a cloth with water and then wipe the
device dry once you have finished.

Technical Data

Model: ................................................................. FF-018.006A
Power supply: ...................................................... 220-240V~50/60Hz
Power consumption: .......................................... 90 W
Protection class: ................................................. Ι
Noise level: .......................................................... 63.1 dB(A)
Maximum fan flow rate: .................................... 76.41 m
Service value: ..................................................... 0.98 (m
Maximum air velocity: ....................................... 4.205 meters/sec
Measurement standard for service value: .... IEC60879:1986 (corr.1992)
4
/min
3
/min)/W
3
Instructions for use