Publicité
Put
bolts
(57),
washers (41) (58) back in, Fig.5,
making sure that the handlebar is
straight and then tighten securely.
Loosen the handlebar bracket, line the
handlebar (36) up with the main post
(59), Fig.6.
Pass
the
hand-grip
through the slot on the post, and pull
them out through the top.
Insert the handlebar (36) in the
bracket of the main mast (59). Fix the
cover (31). Set the handlebar in a
comfortable position and tighten the
handle (29) turning clockwise, Fig.6.
7.- FITTING THE ELECTRONIC
MONITOR.-
Remove the screws (55) from the
base of the monitor, connect the
terminals (59) (60) to those on the
monitor (34), Fig.7, then slide the front
of the monitor down onto the plate on
the main post (59), making sure not to
snag any of the wires, fit the screws
(55) and tighten.
Insert the cover (33) Fig.7. Fix it with
the screws (48) (50), Fig.7.
along
with
their
cables
(60)
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This is
achieved by screwing the adjustable
foot (4) up or down, Fig.8.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (7) to
make it easier to move about. The two
wheels at the front of the unit make it
easier to place the unit in any chosen
position, as shown in Fig.9. Store it in
a dry place, preferably not subject to
changes in temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(71) into the connection hole (k) on the
main body (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Fig.10.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
10
and
then
plug
the
Publicité
