Publicité
Frequency
Submenu allowing the selection of the refresh rate of the LED to avoid a possible «flicking» during
video filming. Changeable values between 900Hz and 25KHz.
Wireless
•
W-DMX: ON to activate the Wireless DMX module from Wireless Solution, or OFF to
deactivate it.
•
Tx/Rx: To switch the Wireless Solution module to transmission mode (Tx) or reception
mode (Rx).
•
Protocol: To select the transmission protocol in G3 (Lumen Radio compatible mode) or
G4S.
(Note: This option only applies to Transmission mode.)
•
Tx/Rx Link:
- Link: To activate pairing mode (in transmission or reception mode).
- Unlink: To break the link with all fixtures paired with the fixture.
(Note: This option is only active when the fixture is in transmission mode (Tx).
•
Rx Reset: YES to reset all reception connections.
(Note: This operation should be performed before any new pairing.)
Fan Set
- Head Fan
Submenu for selecting the head fan speed between Auto (default) and Silent or High.
LCD Set
Submenu allowing to select the behavior of Baracca 360 WET display.
Backlight - 01m to 60m - Selection of the display backlight retention time (without menu manipula-
tion) from 1 minutes to 60 minutes. Time set to 1 minute by default.
Flip Display - ON / OFF - Reversal of the display direction
KeyLock - ON / OFF - Lock the Baracca 360 WET menu buttons.
DispFlash - ON / OFF - Activation or not of the display flash when Baracca 360 does not receive a
DMX signal.
Disp.Set
Chan.Value - continuously displays the DMX values of all channels.
Slave Set - Selection of the slave mode of the Baracca 360 WET to «shift» the Baracca
360 WET when using the Master / Slave mode - between Slave 1, Slave2 and Slave 3.
Auto Prog - Selection of Master / Slave mode:
In MASTER mode Baracca 360 WET transmits information to the Baracca 360 WET
connected using a DMX cable and where Slave mode has been activated
in the "Slave Set" submenu
In ALONE mode the Baracca 360 does not transmit information and executes
its AUTO mode individually.
DFSE - ON / OFF - Reloading the Baracca 360 WET default parameters.
USB Update - ON / OFF - USB activation for software update.
See the procedure on page 52
Page 40
Publicité
