Jaga BRIZA S Manuel page 48

4. SETTINGS VIA CONTROL PANEL
4.1. ADJUSTING THE WATER TEMPERATURE
The default setting of this unit is cooling condensation (deep cooling). If you only wish to cool non-condensing (light
cooling), then you need to adjust the water temperature setting to 24°C.
Adjusting the maximum water temperature for cooling
By reducing the water temperature setting, the unit will
start later. If the water temperature is set higher, the unit
will start sooner.
1. Put the device in the cooling mode
2. Hold down the [Mode] and [+] simultaneously until the last 4 LEDs start flashing.
3. Short press the [-] or [+] button to adjust the set temperature.
4. After 30 seconds, the new settings are automatically saved and the device returns to the selected mode.
48
MODE
12 ̊ C
MODE MODE
14 ̊ C
MODE MODE
16 ̊ C
MODE MODE
18 ̊ C
MODE MODE
20 ̊ C
MODE MODE
22 ̊ C
MODE MODE
24 ̊ C
MODE MODE
26 ̊ C
MODE MODE
JAGA NV | BRIZA S - ON/OFF 3-SPEED CONTROL | MANUEL | 14.10.2024 | V.1.02
Adjusting the minimum water temperature for heating
By increasing the water temperature setting, the unit will
start later. If the water temperature is set lower, the unit
will start sooner.
In combination with a heat pump, it may be necessary
to reduce the water temperature.
1. Put the device in heating mode
15 sec
24 ̊ C
26 ̊ C
28 ̊ C
30 ̊ C
32 ̊ C
34 ̊ C
36 ̊ C
38 ̊ C
/ factory default water temperature