Télécharger Imprimer la page

Jaga BRIZA S Manuel page 47

Publicité

3.1. NOTIFICATIONS
Blue LEDs are flashing: the water temperature for cooling is too high
Red LEDs are flashing: the water temperature for heating is too low
Control panel error codes
MODE
MODE
The LEDs are blinking in a pattern and in the color that matches the selected mode
Only if the window contact is connecrted and switched on: The window contact is open.
MODE
MODE
MODE
3.1.1. Soft reset
If the unit does not respond as expected, you can perform a soft reset. This resets all measured and calculated values in
the controller and restarts the unit. The customised settings are retained.
MODE
1. Put the unit in any mode.
2. Press and hold the [-] and [+] simultaneously until the first 2 and the last 2 LEDs start flashing.
3. Release the [-] and [+].
4. The orange, blue and green lights will illuminate successively, the unit will reset and reboot.
JAGA NV | BRIZA S - ON/OFF 3-SPEED CONTROL | MANUEL | 14.10.2024 | V.1.02
Check the water temperature sensor
MODE
MODE
MODE
MODE
±15 sec
MODE
MODE
MODE
MODE
EN
MODE
47

Publicité

loading

Ce manuel est également adapté pour:

Dpc.br2523