Napoleon TQ285 Instructions D'installation page 11

Leak Testing Instructions
WARNING!
a cylinder is hooked up or if a part of the gas system is replaced.
WARNING!
certain no sparks or open flames are in the area while you check for
leaks. Sparks or open flames will result in a fire or explosion, damage
to property, serious bodily injury, or death.
Leak testing: This must be done before initial use, annually, and when-
ever any gas components are replaced or serviced. Do not smoke while
performing this test, and remove all sources of ignition. See Leak Testing
Diagram for areas to check. Turn all burner controls to the off position.
Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto all joints
and connections of the regulator, hose, manifolds and valves.
Bubbles will indicate a gas leak. Either tighten the loose joint or have
the part replaced with one recommended by the Napoleon Customer
Solutions department and have the grill inspected by a certified gas
installer.
If the leak cannot be stopped, immediately shut off the gas supply,
disconnect it, and have the grill inspected by a certified gas installer or
dealer. Do not use the grill until the leak has been corrected.
TQ285X
PRO285X
N415-0327 NOV 24.21
A leak test must be performed annually and each time
Never use an open flame to check for gas leaks. Be
TQ285
11
EN
PRO285
PRO285X
www.napoleon.com