6. Remove remaining components, parts, and hardware
bags from tub.
Note: Feather plate can be removed by tipping to 45°
angle and pulling out of tub.
Figure 2 - Steps 5 & 6
7. Place motor and chassis plate upside down, with motor
shaft downward. It may be helpful to place chassis plate
onto two blocks or the foam packing for stable support.
Install front and rear legs onto chassis plate using M8
Phillips head bolts and M8 nuts. Hardware should be
placed with Phillips head on motor shaft side. Legs
and chassis plate are labeled with letter decals to aid in
location of legs.
Note: Front round tube legs can be tightened at this
time. Rear square legs should be left slightly loose to aid
in alignment in later assembly.
Check for parts online at www.yardbirdpluckers.com or call 800-345-6007 M-F 8-4:30 CST
8. Install wheels onto the outside of each rear leg using M12
bolts and nuts. Nuts should be toward the inside of the
legs. Tighten bolts and nuts, axle bolt is shouldered so
wheel will spin free with nut tightened.
M8 Nut
4X
M8
Phillips Head Bolt
4X
Figure 3 - Steps 7 & 8
9. Flip chassis plate and motor over to be supported on the
wheels and legs. Install lower handle mount and legs
support straps using M8 Phillips head bolts and nuts. The
rear legs and lower handle mount can be tightened at
this time.
Lower
Handle
Mount
M8 Nut
4X
Figure 4 - Step 9
Operator's Manual
Chicken Plucker
M12
M12 Nut
Hex Head
2X
Bolt
2X
M8 Nut - 4X
(Leave loose
at this step)
M8
Phillips Head
Bolt
4X
Leg
Support
Strap
2X
9