Publicité
10. Slide upper handle onto lower handle mount and install
M8 Phillips head bolts into lowest holes to hold handle
in place. Install hose wrap between lower handle mount
and align with formed loop pushed all the way up. Now
install bracket and nut onto lower bolts and tighten with
M8 nuts.
11. Place M8 Phillips head bolt into bracket and install cord
management wraps onto each side of handle using top
handle mounting holes. Cord management wraps should
be orientated with loop downward. Add M8 nut from
inside and tighten.
12. Install dash at the top of the handle from backside using
M8 Phillips head bolts. Secure cable from dash to motor
along the handle and handle mount tube using included
cable ties.
M8 Phillips Head
Bolt - 4X
M8 Nut
4X
Figure 5 - Steps 10-12
13. Remove cable tie and oil paper from motor shaft and
install feather plate onto shaft by aligning key and
keyway. Key is installed to motor shaft from the factory.
Attached feather plate to shaft using M8 hex head bolt
and domed washer. Domed washer should be installed
with dome upward.
14. Place tub onto chassis plate and latch down to secure.
Note: Ensure tub sensor is aligned to chassis plate
before latching by using alignment arrows on backside
of tub and chassis plate.
15. Install wye valve onto fitting on tub.
10
Upper
Handle
Hose
Wrap
Cord
Management
Wrap - 2X
Bracket
4X
M8 Phillips Head
Bolt - 4X
Check for parts online at www.yardbirdpluckers.com or call 800-345-6007 M-F 8-4:30 CST
Wye
Valve
Key On
Motor Shaft
Figure 6 - Steps 13-15
Figure 7 - Step 14
16. Plug GFCI into wall outlet and press the "RESET" button
on the GFCI. Turn on unit by pressing push button on
dash. Observe for any abnormal noises or vibrations. Unit
should run smoothly and quiet. Stop unit and investigate
if any abnormalities are observed. Unplug GFCI from wall
before diagnosing problem.
Note: Make sure all people and objects are clear of unit
before plugging in, unit may turn on if power button
was depressed during shipping or assembly and will
start once GFCI is reset.
Operator's Manual
Chicken Plucker
M8 Hex Head Bolt
Dome Washer
(Install with
dome upward)
Feather Plate
Align
Arrows
Publicité
