Publicité
UNPACKING AND ASSEMBLY
Tools Required for Assembly:
•
12mm wrench
•
13mm wrench
•
15mm wrench
•
18mm wrench
•
#2 Phillips Screwdriver
Hardware Used:
M8 Hex Head Bolt - Used on feather pan
M8 Phillips Head Bolt - Used on legs, handlebars, dash
M8 Nut - Used on legs, handlebars, dash
M12 Nut - Used on wheels
Dome Washer - Used on feather pan
M12 Hex Head Bolt - Used on wheels
8
Check for parts online at www.yardbirdpluckers.com or call 800-345-6007 M-F 8-4:30 CST
ASSEMBLY
1. Remove top foam packing, then remove the chassis plate,
motor, and tub assembly out of box.
Note: Unit is heavy and may require two people to lift.
2. Place motor and tub assembly with black chassis plate
and motor shaft upward into top foam packing.
3. Remove lower foam packaging and retrieve legs and cord
management wraps from under foam.
Figure 1 - Steps 1-3
4. Remove carabiners and "Z" shaped shipping straps from
tub buckles to separate motor and chassis plate from tub.
Note: "Z" shaped shipping straps are for shipping only
and can be discarded.
- "Z" shaped shipping strap
5. Lift chassis plate and motor assembly out of tub and set
aside.
Operator's Manual
Chicken Plucker
Publicité
