Publicité
PR158DVK/PR159DVK/PR160DVK
•
Remove the exterior and interior packing, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Dry the appliance off
well.
•
Let air circulate freely around the cabinet.
•
Make sure there is sufficient space to open the door.
•
This cooling unit is not intended for use as a built-in appliance.
•
Select a place with a strong, level floor.
•
Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating.
Heat sources nearby will cause higher electricity consumption.
•
Avoid very moist places. Too much moisture in the air will cause frost to form
very quickly on the evaporator, and your freezer.
•
Before connecting your freezer to the power supply, check that the voltage
stated on the rating label of your appliance corresponds to the voltage in your
home. A different voltage could damage the appliance.
•
After installation, leave the freezer for 24 hours before turning it on. This way
the refrigerant can settle.
•
Allow the appliance to run empty for 12 hours so the compartment can cool to
the appropriate temperature.
•
The climate class indicates the minimum and maximum ambient temperature
for the proper operation of an appliance. You can find the climate class on the
type plate on the back of the appliance.
- SN: Subnormal: ambient temperature between 10°C and 32°C
- N: Normal: ambient temperature between 16°C and 32°C
- ST: Subtropical: ambient temperature between 16°C and 38°C
- T: Tropical: ambient temperature between 16°C and 43°C
INSTALLATION
65
WWW.PRIMO-ELEKTRO.BE
Publicité
