Publicité
EN
SET-UP AND CONNECTION
Please Note!
■ Only connect the base station to a
properly installed plug socket. The mains
voltage must match the technical data
of the device.
■ Do not place the device below kitchen
wall units or similar cupboards. The rising
steam could cause damage to them!
■ Make sure that the connecting cable does
not present a trip hazard. It should not
hang down from the surface on which
the device is placed in order to prevent
the device from being pulled down.
■ Lay the connecting cable in such a way
that it does not become squashed or
bent and does not come into contact
with hot surfaces.
1. Unwind the connecting cable on the bot-
tom of the base station to the required
length and place it in the cable winder.
2. Always set up the device with a clear
space at the sides (at least 20 cm) and
clear space above it (at least 30 cm) on
the kitchen worktop or another flat,
solid and heat-resistant surface that is
resistant to splashing.
3. Plug the mains plug into a plug socket.
The plug socket must be readily accessi-
ble so that the connection to the mains
can quickly be isolated.
BEFORE INITIAL USE
1. To remove any possible production
residues, fill the kettle up to the MAX
mark with water before you first use
it and switch it on. To do this, follow
the instructions in the "Set-Up and
Connection" and "Use" chapters.
2. Pour away the water after boiling.
Do not drink this water!
3. Perform this process twice.
12
USE
Please Note!
■ Each time before you boil water, make
sure that the On / Off switch is not
blocked. The kettle will only switch off
automatically after the boiling process
finishes if the On / Off switch is not
blocked.
■ The lid must always be closed during
operation.
■ Never operate the device without water
or with the water level below the MIN
mark. It could overheat. In this case,
the device switches off. Allow it to cool
down before refilling and reusing it!
1. Pull the release button for the lid towards
the handleand open up the lid.
2. Fill the kettle with at least 0.5 litres
(MIN mark) and no more than 1.8 litres
(MAX mark) of water. Insufficient water
will cause the device to switch off pre-
maturely. If the MAX mark is exceeded,
water could splash out during the
boiling process.
3. Flip the lid shut. It must engage.
4. Place the kettle on the base station.
5. Move the On / Off switch to position I.
The device and the operating lamp are
switched on.
L
The boiling process can be stopped
at any time by moving the On / Off
switch to position 0.
6. The device switches off automatically
as soon as the water boils. The On /
Off switch flips to position 0 and the
operating lamp goes out.
7. Take the kettle off the base station and
carefully pour the water into a vessel.
Publicité
