Publicité
WARNING:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during use
to avoid serious injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
„ Edging around walkways, curbing, flower beds and other
similar areas.
ASSEMBLY
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
„ Stop the engine or motor and remove the spark plug
wire, disconnect from the power supply, or remove the
battery pack.
„ Loosen the knob.
„ Push in the button and twist the shafts to remove and
separate ends.
OPERATION
USING THE EDGER ATTACHMENT
See Figure 3.
WARNING:
Engine housing on gas power heads may become hot
during edger operation. Do not rest or place your arm,
hand, or any body part against the engine housing during
edger operation. Only hold the edger as shown in Figure
3 with all body parts clear of engine housing. Extended
contact with the engine housing can result in burns or
other injuries.
WARNING:
Always position the unit on the operator's right side. The
use of the unit on the operator's left side will expose the
operator to hot surfaces and can result in possible burn
injury.
WARNING:
To avoid burns from hot surfaces, never operate unit with
the bottom of the engine above waist level.
When using the edger attachment, hold the unit with your
right hand on the rear handle and your left hand on the front
handle. Keep a firm grip with both hands while in operation.
The edger should be held at a comfortable position with the
rear handle about hip height.
NOTE: When used with a gas power head, always operate
at full throttle. Prolonged cutting at partial throttle will result
in oil dripping from the muffler.
6 — English
Publicité
