Publicité
KNOW YOUR EDGER ATTACHMENT
See Figure 1.
The safe use of this product requires an understanding of
the information on the product and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all op-
erating features and safety rules.
UNPACKING
This product requires assembly.
„ Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
„ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
„ Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
„ If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Edger Attachment
Holding Pin
Hanger Cap
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
FEATURES
PRODUCT SPECIFICATIONS
Blade Length..................................................................8 in.
Edging Depth.................Adjustable from 1/2 in. to 2-1/4 in.
Replacement Blade................................................AC04215
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power head until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
JOINING THE POWER HEAD TO THE EDGER
ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine/motor and remove
the spark plug wire, disconnect from power supply, or
remove the battery could cause serious personal injury.
The edger attachment connects to the power head by means
of a coupler device.
„ Remove the spark plug wire, disconnect from the power
supply, or remove the battery pack.
„ Remove the hanger cap from the attachment.
„ Loosen the knob on the coupler of the power head shaft.
„ Push in the button located on the edger attachment. Align
the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate attachment
shaft until button locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into place.
„ Tighten the knob securely.
5 — English
Publicité
