Publicité
Maintenance and Storage
Cleaning the filters
The filter(s) must be cleaned after each cleaning cycle. Press the button to
release the lid and pull out the filter(s). Spray water on the outer sides of the
filter and then spray water towards the inner side of the filter to clean all the
dirt and debris. Reinsert the filter(s).
Storing the robotic cleaner
Follow these instructions to store the robotic cleaner when not in use:
Disconnect the power cord from the wall outlet. Disconnect the floating cable
from the power supply. Make sure that the power supply is not exposed to
water. Spread out the floating cable and roll it. Wash the interior and exterior
of the cleaner unit with fresh water and let it dry. Roll the floating cable and
place it on the cleaner unit. Caution: Store the robotic cleaner components in a
dry, closed location.
Checking water outlet propeller
It is recommended to periodically clean debris and hair from the propeller of
the water outlet: (1) Unscrew the outlet locker that secures the outlet cover. (2)
Remove the water outlet cover (3) Clean any hairs, dirt, or debris. (4) Return the
outlet locker resecuring the outlet cover.
Single or double filter depends on the model
5
F1 R | F1 RX ROBOTIC POOL CLEANER
Publicité
