Publicité
Operating procedure
The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Light
Fan OFF
Reduce fan speed
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching the fan ON
Press the + button.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
The displayed
goes out shortly
{
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed
goes out shortly
{
afterwards.
14
Display for
Fan follow-
fan setting
on
Fan ON and
increase
speed
Intensive
setting
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step
after 10 minutes.
}
Fan follow-on:
Press the
button.
The fan continues to run at step
10 minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
The light can be switched on at any
time, even though the fan is switched off.
RemoteControl:
The hood is equipped with a remote
infrared control with 4 push buttons
which enables to switch on and off the
light, to switch on and off the hood and
to regulate the speeds.
+ Increases the motor speed.
– Reduces the motor speed till it stops.
The fan continues to run at step
10 minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
0
LIGHT.
The infrared remote control is fed by a
battery.
When battery is exhausted it is
necessary:
1. To open the small door located on the
underside of the remote-control, sliding it
in the direction of the arrow (see Fig.6).
2. Extract the battery and replace it with a
new one having the same characteristics.
3. Put the small door of the battery back.
Follow National norms for waste disposal of
batteries.
ç
for
|
for
|
Publicité
