Publicité
15. Temporarily remove the Bolt from the Relay bracket.
16. Pull the Relay bracket out of the way and route the
Hood Switch Harness underneath.
17. Reinstall the Bolt to the Relay bracket.
• Tighten the Bolt to 7.5 N·m (0.8 kgf·m, 5.5 ft-lb)
18. Secure the Hood Switch Harness to the Vehicle
Body using a Harness Clamp.
• Clean attachment surface using isopropyl alcohol and
cleaning towel.
19. Pull out the Vehicle's Black 2P Pre-Connector from
the Vehicle harness.
20. Cut the Foam Tape to the suitable size.
21. Attach the Foam Tape to the Vehicle's Black 2P
Pre-Connector.
22. Connect the Sub-Harness 2P Black Connector to
the Vehicle's 2P Pre-Connector.
- 15 -
Publicité
