Publicité
PROCEDURE
E Procedure
(1) Before installation and wiring, remove the © terminal of the battery to prevent
snort-circuiting.
(2) Connect the input and output cords of the system. (cr P. 6)
(3) Connect the Ground lead to the metal chassis of the car. (7 P. 7)
(4) Connect the Power supply lead (Red). («7 P. 7)
(B) Install the unit in the car. (cr P. 8)
Connect the negative © terminal of the disconnected battery.
À CAUTION
e. A short-circuit may be the cause of biown fuse. A short-circuit is a serious
problem that can lead to a fire. Check the wiring and rewire if any wires are short-
circuited. After this (or if no short-circuits are found), replace the fuse with one
having the same capacity (see indication on unit}.
e Make sure that unconnected wires and connectors are not in contact with the live
chassis (ground) of the car to prevent noise and current from entering the system
which can cause it to malfunction or damage the unit. For the same reason, caps
on connectors that are not used should not be removed.
Publicité
