Publicité
EN
6.
Extend the cutting line to release it from the guide
slot in the spool.
7.
Push the tabs and install the spool cover onto the
spool housing (5).
8.
Push the spool cover until it clicks into position.
10.4
REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of .0080" (2 mm)
diameter.
1.
Cut a piece of cutting line approximately 3m long.
2.
Bend one end of the line 1/4 of an inch (6.35mm)
English
5
4
NOTE
NOTE
3.
Insert the line into the anchor hole of the spool.
4.
Wind the cutting line around the spool tightly in
the indicated direction.
5.
Put the cutting line in the guide slot.
6.
Do not wind the cutting line beyond the edge of
the spool.
11
TRANSPORTATION AND STORAGE
11.1
MOVE THE MACHINE
When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
11.2
STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
12
Publicité
