After Use - SilverCrest SND 3600 D3 Mode D'emploi

Colour and brightness settings
♦ Adjust the colours and brightness as required by clicking on the
"Color/Brightness adjustment" button (K) . A settings window
appears .
♦ Move the "Brightness" slider to set the brightness between
0 and 255 .
♦ Move the three "Color Balance" sliders to set the RGB values
between 0 and 255 .
♦ To reset to the default values, click on the "Default" button .
♦ To accept the new values and close the settings window, click on
the "Exit" button .

After use

♦ Remove the negative holder
the device .
♦ Remove the slide magazine
slot on the right .
4
♦ Remove the USB cable
and the scanner .
SND 3600 D3
by pushing it all the way through
5
by pulling it back out of the
6
from the USB port on your computer
8
GB │ IE │ 43 ■