Publicité
Safety Instructions (Continued)
•
Do not touch the hot surfaces.
•
Always ensure that your hands are dry before operating or adjusting any switch on the
product or touching the plug and socket.
•
Do not leave this appliance unattended when it is in use.
The most common cause of overheating is deposits of dust or fluff in the appliance.
•
Ensure these deposits are removed regularly by disconnecting the appliance and then
vacuum cleaning the air vents and grills.
•
Do not place the heater on a carpet or put the cable under a carpet.
Place the cable in such a way that it is not in any high traffic area to avoid it being
•
tripped over or stood on.
•
Do not put the heater away until it has cooled down completely. Store the heater in
cool dry location when not in use.
•
This product is only suitable for well insulated spaces or occasional use.
Some parts of this product can become very hot and cause burns.
•
Particular attention has to be given where children and vulnerable people are
present.
If the machine is operated with a defective or damaged mains cable,
there is a potential danger of fatal electric shock.
Never use a machine which is damaged or has a damaged mains cable.
In order to avoid a hazard for very young children, this heater should be
installed so that the lowest part of it is 120cm above the floor.
This heater should be installed in accordance with the British IET BS 7671
Regulations.
Technical Specifications
Model
Rated Voltage
220 - 240V
Rated Frequency
Rated Power
Protective Class
IP Code
Rated IP24 - protected against solid
BFH20
objects over 12mm, e.g. fingers,
and, protected against water
splashed from all directions, limited
50-60Hz
ingress permitted.
2000W
II
IP24
6
Installation
As a general guideline, please see the below diagrams which illustrate how and where to
install the heater safely.
Figure 1.
A. Bath
B. Shower
B
C. Sink
A
C
Install the heater at least 0.5m away from all
water sources. Do not place it above a bath
or shower.
Step 1
x3
x2
235mm
Hold the heater on the wall
Insert wall plugs into the
in your chosen position and
holes and tap into place with
mark the screw holes with
a hammer.
a pencil, then use a drill to
make the holes.
Next, insert the screws into
the wall plugs and screw into
place leaving 6mm of screw
exposed from the wall.
Figure 2.
0.3m
MIN
0.25m
0.25m
MIN
MIN
0.4m
MIN
1.2m
MIN
Install the heater with space around it as
shown in Figure 2.
Step 2
Step 3
x1
Align the heater with the
screws you have installed
on the wall and carefully slot
them into place.
Then use the last screw to
secure the top of the heater
to the wall.
7
Publicité
