Publicité
3
Technical Data charger and battery
Battery:
U = Voltage
C = Capacity
W = Weight
Ic = Charge current
t
= Approx. charging time (90% full)
Charging voltage...........20,75 V DC
Charging temperature .. 0° - 50° C, 32° - 122° F
Max. discharging
temperature. ................. 5° - 50° C, 41° - 122° F
Recharge battery pack before first use!
4
Function of the Unit
4.1
Overview
Battery
1
Gear box
2
Head housing
3
Tube fastener adjustment
4
Tube fastener (clamp)
5
4.2
Changing the battery
Slide the battery in until you hear it lock into place. Remove the battery by pressing down on the
lock and then pulling the battery out.
Using a battery with at least 4.0Ah is recommended to ensure the optimum processing of pipes
with large diameters. Otherwise, the device's power might be insufficient and the device will
switch off during the operating cycle.
4.3
Operating
Before carrying out any operations with the machine, first read the general safety
instructions and preparations for start up!
Never reach into the area around the rotating parts!
Always keep one hand on the appliance's handle so that you can operate the On / Off
switch. Do not lock the On switch in place during operation so that you can react quickly!
Fasten the tube clamp securely and check that the machine's anchor bolt is parallel to the
tube to be threaded. The bolt should extend over the end of the tube by approximately 1 or
1.5 cm.
Choose the threading head according to your needs and mount it in the octagonal coupling
of the machine. Fit the adapter first, when using a 1.1/4" head. For right thread, insert the
threading head ad the front of the machine. For left thread, insert the threading head at op-
posite end of the machine.
When using the adapter, this should be directly inserted in the octagonal coupling of the ma-
chine on the same in which the threading head has been inserted (right thread: front side;
left thread: opposite side) and secured by its threaded cap.
To insert the head into the adapter, move the mobile part of the latter counterclockwise until
it is completely inserted. This will spring back securing the head. To remove it, proceed in
likewise manner.
Next insert the machine in the tube and make sure that it is securely guided into its housing
by the tube clamp bolt.
18
Charger:
U1
= Input voltage
f1
= Input frequency
P1
= Input power
U2
= Charging voltage
I2
= Max. charge current
Nc
= No. of battery cells
W
= Weight
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
Bolt.
6
Reverse speed lever
7
ON switch
8
Adapter monoblok 1/4"-1.1/4"
9
Adapter euroblok 1/4"-1.1/4"
10
ENGLISH
(D)
(A)
(B)
(C)
Publicité
