Publicité
5. Setting the DMX Address: Once you have activated the DMX
Mode as step 1, you can use the « UP » and « DOWN » arrow buttons
to select your desired DMX address from 001~512.
SEE ANNEX - FUNSTRIP 180 LH DMX CHART (P 21)
Chase Mode:
Use the operation mode only when you are about to use your unit in auto mode.
1. Selecting the Chase Mode: Chase Mode is indicated by « P »
followed by two digits. «P» stands for Chase program and means the
Chase Mode has been activated at present, and you have also acti-
vated the Chase Program Mode. After activating the Chase Mode, the
Chase Program Mode starts initially and is the default setting. If « A »
appears in the LED display, means you are in the DMX mode.
« A » stands for DMX address.
2. Setting your desired Chase Program: Once you have activated
the Chase Mode as in step1, you can use the « UP » and
« DOWN » arrow button to change your selected chase program. The
chase pattern is displayed in the LED by « P » followed by two di-
gits01~16 or only « AUTO » & « FULL » appears. You can select any of
them to run at a single time.
3. Selecting the Chase Speed Mode: To adjust the Chase Speed,
you must activate the Chase Speed Mode. Of course, only while in
the Chase Mode as step 1, press and hold the « MENU » button until
« SP » followed by two digits appears in the LED. « SP » stands for
the chase speed.
4. Setting your desired Chase Speed: In this mode, you can adjust
the program chase speed. Use the « UP » and « DOWN » arrow but-
tons to adjust the chase speed from 01thru 99. A set value of 99 will
give you the fastest chase speed (approx.1/10th of a second).
While a set value of 01 will give you the slowest chase speed (once
every 30 second).
User Manual - FUNSTRIP 180 LH
V1.1 05/2022
A:001
P:01
P:01
SP:01
SP:01
8/28
Publicité
