Publicité
Power:
Before plugging your unit in, be sure the ressource voltage in your area matches the unit
required voltage. The unit is available in 110V or 230V version only. Because the line voltage
may vary from venue to venue, you should be sure to plug the socket into a matching wall
outlet before attempting to operate your unit.
Fuses:
The « Funstrip 180 LH » is protected by F2A 250V 5*20mm. Please see the printing on the
case. This fuse prevent you from overloading damaging your unit. To replace the protective
fuse, use a flat head screwdriver to unscrew the fuse holder. Pull out the old fuse and replace
it with a new one. Insert the fuse back into the slot and tighten. Always replace with exact
same type fuse removed unless otherwise specified by an authorized service technician.
5. Overview
8
9
1. LED Display
2. Menu button
3. Up button
4. Down button
5. Enter button
6. Fuse
7. Power Switch
8. DMX Out
9. Power Output
10. DMX In
11. Power Input
User Manual - FUNSTRIP 180 LH
1
2
3
4
5
This multi-function display will detail all DMX Adress, Chase, Program,
Speed activity that pertains to the current operation mode of the unit.
This button will call up the unit operation mode between DMX and
Chase mode.
This button will increase the displayed value in the LED display.
This button will decrease the displayed value in the LED display.
This button will active the different functions in DMX and Chase mode.
Note: In the Chase mode, Menu key is used to only activate Chase
Dimmer (d), Chase Program (P), Chase Speed (SP).
In the DMX mode, only used to select DMX Address (A), Channel (CH).
F2A 250V 5*20mm. This fuse prevent you from overloading damaging
your unit. Be sure to always replace with the exact same type fuse.
Turn on/off the power supply.
To connect your DMX signal through to the next unit.
AC 230V-50Hz, Max 16A
To connect your your DMX input signal.
AC 230V-50Hz, Max 16A
V1.1 05/2022
6
10
7
11
6/28
Publicité
