Publicité
6. Operation Guide
Operation Modes:
The « Funstrip 180 LH » has two different operation modes. It can be used a 10 channel
chaser or in DMX mode. Please follow illustrations below
to operate the unit in your desired mode.
DMX Mode:
Use this operation mode only when you are about to use the unit as a DMX dimmer.
This function allow you to set address and DMX mode.
1. Selecting DMX Adress: DMX adress is indicated by an « A »
followed by three digits in the LED. « A » stands for DMX Address and
means the DMX Mode has been activated at present. If «P» appears
in the LED display, means you are in the Chase Mode. (Program)
2. Selecting the Channel Mode: Channel Mode is indicated by
« CH » followed by two digits 01,02, 02, 04, 05, 10, 10, 20, 15, 25. You
can not use the « ENTER » button to select the Channel Mode unless
you have called up the DMX Operation Mode as in step 1.
3. Setting the Channel Value: Once you have activated the Channel
Mode as in step 1, you can tap the « UP » and « DOWN » arrow but-
tons to change the setting which you wish to run.
4. Selecting DMX Address Mode: DMX Address Mode is indicated
by « A » followed by three digits 001 ~ 512. You can not use the
« MENU » button to select the DMX Address Mode unless you have
activated the DMX Mode as step 1. This mode is the factory default
setting.
User Manual - FUNSTRIP 180 LH
V1.1 05/2022
A:001
CH:001
CH:001
A:001
7/28
Publicité
