Stadler Form Eva Mode D'emploi page 9

quietly and in an energy-efficient way. The lower the current humidity is,
the higher the humidification output level will automatically be set (under
33 % = level 4, from 34 % – 37 % = level 3, from 38 % – 41 % = level 2, from
42 % – 45 % = level 1). You can change the desired humidity in auto mode
by pressing the "Hygrostat" button (11) several times while auto mode is
active (the LED on the "Auto" button on the unit is on). The humidification
output level (12) cannot be altered manually in auto mode. As soon as the
"Output" button (12) is pressed to change the humidification output level,
the auto mode is deactivated.
11. You can use Eva to disperse fragrances in the room. Be extremely sparing
with fragrances because an excessive dosage can result in the malfunc-
tioning of, and damage to, the appliance. In order to use fragrances, briefly
press and release the fragrance container (20) and pull it out of the appli-
ance. Let the fragrance drip directly onto the cotton pad in the fragrance
container (20). Add a maximum of 1 – 2 drops of fragrance into the fra-
grance container! Push the container back again and press and release it
to lock it. Tip: in order to change the fragrance, remove the cotton pad and
clean the container with soap. Now you may insert a new cotton pad (com-
mercially available) and add drops of the desired fragrance.
12. If the water level indicator (16) changes to red, the water must be refilled.
Remove the water tank (6) and fill it with clean, cold tap water up to the
maximum mark. Replace the water tank and press the on/off button (10).
The appliance will resume operation after a few seconds. The water tank
can also be refilled during operation.
13. If you find the lamps too bright (in a bedroom, for example), you may re-
duce the light intensity by pressing the night mode key (21):
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into normal
mode.
If there is no water in the appliance, the red water level symbol (16) lights
up in all modes. The red light cannot be dimmed.
14. If two dots are shown (22) on the display (15), Eva cannot establish a radio
connection to the Remote Sensor
midity sensor within the appliance. Press any button on the Remote Sen-
sor (2) to activate it. Make sure that the Remote Sensor
TM
10 m radius of Eva. Walls, doors and floors between Eva and the Remote
Sensor (2) can disrupt the radio connection. The Remote Sensor
TM
should be optimally positioned at a distance between 3 – 5 m from Eva and
on an elevated surface in the middle of the room (see «Setup/operation»
No. 3). The two dots on the display (22) could also indicate that the bat-
teries in the Remote Sensor
No. 2).
15. Press the button for night mode (21) for 5 seconds to connect Eva to the
"Stadler Form" App or the "Smart Life – Smart Living" app from Tuya Inc.
(available from the App Store and via Google Play) on your smartphone.
The flashing water level indicator (16) shows that WiFi is switched on. You
can control all the functions of the appliance via the app and monitor the
air quality in real time, even when you are not at home. For more detailed
information on how to connect your Eva to your smartphone, see the en-
closed "WiFi – Quick Setup Guide"
(2). Eva still functions thanks to a hu-
TM
(2) need replacing (see «Setup/operation»
TM
(2) is within a
TM
(2)
TM