Stadler Form Eva Mode D'emploi page 8

2. Take the Remote Sensor
the packaging. Open the battery compartment (4) on the underside of the
Remote Sensor
teries into the battery compartment (4), as shown on page 4, and close
the lid again.
3. On the one hand, the Remote Sensor
antees precise humidification by its external position. On the other hand,
the Remote Sensor
humidity sensor Remote Sensor
or a sideboard with an optimal distance from Eva between 3 – 5 m. The Re-
mote Sensor
air can flow past the sensor (5) as freely as possible. If this is not possible,
we recommend positioning the Remote Sensor
of 30 cm from the wall and a minimum distance of 2 m from windows and
ventilation openings.
4. Remove the water tank (6) by holding it by the handle and pulling it up.
Screw off the water tank lid (7) and fill the water tank with clean, cold tap
water up to the maximum mark. Make sure that the anticalc cartridge (8)
has been soaked in water for 24 hours prior (see "Before setup"). Finally,
screw the lid (7) back on the water tank (6). Then place the water tank
(6) in the unit. The water tray (9) will now slowly fill from the water tank.
Important: please do not move the appliance when it is filled with water.
The water could run into the electronics.
5. Press the on/off button (10) to switch Eva on. The current relative humidity
in % is shown on the display (15). If the water level indicator light (16) is
red, there is too little water in the unit. The humidification output level is
pre-set to level 3 and the desired humidity at 45 %.
6. Activate the Remote Sensor
The humidity sensor automatically sends information about the measured
relative humidity several times per minute to the unit, which shows it on
the display (15). The measurement can also be activated by pressing any
button on the Remote Sensor
7. The desired humidity can be changed by pressing the "Hygrostat" button
(11) several times (30 – 75 % and continuous operation "CO"). The symbol
on the display (15) blinks during input. After a few seconds without input,
the selected value is saved. The symbol changes to the current measured
humidity.
Info: Once the desired air humidity is reached, the appliance stops and the
display blinks. Should the measured current air humidity fall below the set
value, the appliance begins to humidify again.
8. The humidification performance can be changed by pressing the "Output"
button (12) several times (levels 1 – 5). The level is indicated on the display
(15) by horizontal bars (e.g. 1 bar = level 1).
9. By pressing the "Warm" button (13), the warm mode, and with it the water
pre-heating, is turned on. Now the LED on the "Warm" button on the unit
is on. The heating plate (17) warms the water before it is turned to mist by
the ultrasonic membrane (19). The warm mode creates a pleasantly warm
mist plus increases the humidification performance.
10. By pressing the "Auto" button (14), the auto mode, and with it the Adaptive
Humidity Technology, is activated. Now the LED on the "Auto" button on
TM
the unit is on. In auto mode, the unit adapts the humidification output level
automatically in order to reach and maintain the desired humidity of 45 %
(2) and the two batteries (Type AAA) out of
TM
(2) by pushing the lid downwards. Insert the two bat-
TM
(2) also serves as a remote control (3). Position the
TM
should be positioned centrally in the room so that the room
TM
TM
(2) is a humidity sensor and guar-
TM
(2) in the centre of the room on a table
TM
(2) by pressing the "Hygrostat" button (11a).
(2) (aside from the on/off button (10)).
TM
with a minimum distance
TM