Publicité
Installing the alkaline batteries
• Keep your hands and the main body dry.
• Make sure that the switch is set to "0".
1. Pull the main body and remove it from the tank.
2. Install the alkaline batteries.
Remove the battery cover. (Fig. 1)
Insert the batteries. (Fig. 2)
Align the battery cover with the battery compartment,
and attach the battery cover by sliding it into place.
(Make sure that the battery cover and the battery
compartment are firmly installed and there is no gap.)
(Fig. 3)
3. Install the tank.
Note
• Use only LR6 (AA Alkaline battery), otherwise the power
or number of uses may vary.
Filling the tank with water
1. Pull out the main body until you see the " " mark.
(Fig. 4)
a
Pull-out mark
2. Install the nozzle while holding the main body. (Fig. 4)
Press in the nozzle firmly until a "click" is heard.
b
3. Add water. (Fig. 5)
• Always use fresh tap water or lukewarm water.
• If you feel the water is cold, use lukewarm water with a
temperature of up to 40 °C.
Full-water position
c
11
Publicité
