Publicité
CLEANING AND MAINTENANCE
IMPORTANT: do not use corrosive or abrasive
detergents. The
transparency
compartment and/or the front cover and/or cover
may change over time but this does not affect the
performance of the appliance.
REPAIR SERVICE
IMPORTANT If you notice that your vacuum cleaner
is operating less well, and before carrying out any
checks, switch it off using the ON/OFF pedal.
If your vacuum cleaner does not function
• he appliance is not powered. Check that the appliance is
plugged in correctly.
If your vacuum cleaner has no suction
• An accessory, the tube, hose, separator (14a), air/dust
divider (14b) or the separation compartment (14c) is blocked:
unblock it.
• The black foam filter (16a) is saturated: clean it.
• The microfilter (16b) is saturated: clean it.
• The HEPA filter (15) is saturated: clean it by patting it over a
dustbin. If the HEPA filter is damaged, fit a new filter.
If your vacuum cleaner suction is not working properly or is
making a whistling noise
• An accessory, the tube, hose, separator (14a), air/dust
divider (14b) or the separation compartment (14c) is partially
blocked: unblock it.
• The dust compartment is full: empty and wash it.
• The vacuum cleaner cover is not fitted correctly: close the
cover correctly.
• The dust compartment is not correctly fitted: reposition it
correctly.
• The manual power control* on the grip is open: close it.
ENVIRONMENT
In accordance with current regulations, any appliance
that is no longer used must be made permanently inoperable:
disconnect and cut off the power cord before disposing of the
appliance.
• Environment: Directive 2002/95/EC.
* Depending on models: either equipment specific to cer-
tain models or available as an optional accessory.
ATTENTION: do not wash the vacuum cleaner cover
of
the
dust
under water. Clean it using a soft damp cloth.
If the cone separator (14a) fills up
• Dust accumulates in the separation compartment (14c):
check that the pipe between the separator (14c) and the dust
compartment (11)
is not blocked. Check that nothing is obstructing the dust
compartment inlets.
• The dust compartment inlets are obstructed: remove the
dust compartment and empty it. Clean the dust
compartment seals.
If the suction attachment is difficult to move
• Open the manual power switch* on the grip.
If the power cord does not wind up completely
• he power cord is slow to wind up: pull the cord out again
and press on the power cord rewind pedal.
If a problem persists, take your vacuum cleaner to your local
Rowenta Approved Service Centre.
For a list of Approved Service Centres, contact the Rowenta
Customer Service; contact details are in the attached international
guarantee form.
11
Let s help preserve the environment!
Your appliance contains numerous materials
that can be reused or recycled.
Take it to an electric appliance collection point,
where it will be disposed of correctly.
EN
Publicité
