Publicité
About Your Refrigerator
Usage:
This refrigerator is made for use within a recreational vehicle. As such, it is suitable for camping and boating, but do not
expose the refrigerator to rain or snow.
Storage Volume:
This refrigerator is made to store fresh and frozen foods and for making ice.
Total capacity NV10DC
Total capacity NV8DC
The refrigerator is made to operate within 10° off level in all directions. Operating it at more than these limits can
cause damage to the cooling system, increased noise and poor cooling performance. Make sure the vehicle is level
!
CAUTION
before you operate the refrigerator.
Operation During Travel:
While the refrigerator should be level when the vehicle is stopped, performance during travel is not usually affected.
Food Compartment:
Start up the refrigerator and let it cool for eight hours before loading with food. If the refrigerator does not start to cool down after about
two hours, contact your dealer or an authorized Norcold Service Center.
For the best cooling performance:
- Let air move freely inside the entire food and freezer compartments.
To decrease the amount of ice that collects on the rear wall of the refrigerator freezer and fresh food.
- Cover all liquids and moist foods.
- Let all hot foods cool before putting them in the refrigerator.
- Do not open the door any longer than necessary.
Freezer Compartment:
The freezer compartment is made to keep pre-frozen food frozen and not to quick freeze food. Keep pre-frozen foods in the freezer
compartment.
NOTE: When making ice, put the ice cube tray directly on the bottom of freezer. Do not put other items on the ice
NOTICE
cube tray while the water is freezing. The water freezes more rapidly if the power switch / thermostat is at the coldest
temperature setting.
Door Latch for Travel:
During travel, the door latch prevents the door from opening. When closing each door, push the door toward the refrigerator until you
hear a "click" sound. To open each door, pull the handle away from the refrigerator.
Interior Light:
The interior light is located on the top of the fresh food compartment.
The interior light comes on when the refrigerator is ON and the door is open.
To replace the bulb:
1. Use tape to hold the light switch down, which removes power from the light circuit.
2. Remove the electrical cover with a screwdriver. The LED light is integrated with the
main Power Control Board (PCB). Remove the main PCB (See ART02801).
3. Unplug wire harness connector.
4. Install the replacement PCB
10.0 cubic feet
Calculated according to ANSI/AHAM-HRF-1-1988
8.4 cubic feet
Calculated according to ANSI/AHAM-HRF-1-2016
LED Right
Owner's Manual 5
Publicité
