Publicité
For the next two steps you will be allowed 20 seconds only.
•
Push both gimbal sticks in any corner and hold them there.
•
Switch off the transmitter.
•
Wait for "QUIT" signal (may take up to 30 seconds).
•
Release sticks and move pitch into minimum position; "QUIT"
•
Move the Tail Control stick all the way to the right; "QUIT", release tail stick.
•
Move the Forward Pitch stick all the way forward; "QUIT", release forward pitch.
•
Move the Roll stick all the way to the right; "QUIT", release roll.
•
Optional: Flight Phase Switch to Acro; "QUIT", back to normal position (not necessary for rpm control)
•
Optional: Three Position Switch Mode in position Heading Lock; "QUIT", back to Motors Off. To activate the Auto
Rotation Function move the Three Position Switch Mode again to Heading Lock; "QUIT", back to Motors Off.
•
Optional: Switch on additional switches in sequence; wait each time for "QUIT" and then switch back.
•
Move Pitch all the way forward and back, response is a long "QUIT". The programming procedure is finished, the
LED will flash green.
Attention: You may invert functions at the model by repeating the programming at that function and moving the
respective gimbal stick to the opposite side (only possible with GigaTronic V2). Alternatively you may reverse
the function at the transmitter.
Take-Off preparation after channel assignment
•
(optional) Flight Phase Switch to Hover, Mode to Off
•
Move Pitch to minimum
•
Switch on transmitter
•
Connect flight battery
(Depending on the receiver used it may take several seconds until the receiver LED indicates stand-by mode.
Should the GigaTronic LED flash red, just disconnect the flight battery and reconnect it again.
•
System initialization.
•
System ready for operation. GigaTronic LED flashes green.
•
Check directional movement of Pitch and Swash Plate.
•
(Optional) Move Mode Switch to Heading Lock, LED will light up green.
•
System is ready for take off.
Configuring the GigaTronic
With the GigaTronic you have the possibility to set up your helicopter entirely as per your desire. The optionally available
"GigaTronic Control" software will allow you to easily adjust all settings via your PC and transfer them with the included
interface cable to the GigaTronic.
7
Publicité
