Publicité
Problem
Light on, but motor does not
work
Light does not work, motor does
not work
Oil leakage
Hood body shakes
Insufficient suction
The hood is slanted
Troubleshooting
Cause
The motor blocked
The capacitor is damaged
The motor bearings are jammed
or damaged
Beside the mentioned above, check the following:
Light is damaged
Wires are loose or disconnected Connect the wires as per the
The one-way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection of
U-shaped section and cover
The motor damaged and causes
shaking
The motor is not tightly attached Tighten motor
The body is not tight
The hood is installed too high
(too much distance between
hood and cooktop)
Too much ventilation from open
doors or windows
The fixing screw is not tight
enough
The hanging screw is not tight
enough
— 22 —
Solution
Get rid of the blocking
Have capacitor replaced
Have motor replaced
Replace lights
electric diagram
Take down the one way valve
and seal with glue
Take U-shaped section down
and seal with soap or paint
Have motor replaced
Tighten the body
Install hood at the appropriate
height
Close doors or windows
Place hood in its proper position
and tighten the fixing screw
Place hood in its proper position
and tighten the hanging screw
Publicité
