Publicité
Installation
STEP 12
Install Filters
To install filters for the following four steps (See Figure #18):
• Angle the filter into slots at the back of the hood.
• Push the button on handle of the filter.
• Release the handle once the filter fits into a resting position.
• Repeat to install all filters.
Fig #18
Cleaning Filters
IMPORTANT: Drain oil from spacers, filters, oil tunnels, oil containers before oil and residue overflow!
• Remove all spacers, filters, grease tray, and oil containers and discard oil and residue.
• Wash with warm soapy water. NOTE: Stainless steel filters, spacers and oil tunnel are top rack dishwasher safe.
• Dry thoroughly before replacing and follow directions for installation in reverse.
• Filters should be cleaned after every 30 hours of use.
• Should filters wear out due to age and prolonged use, replace with a new filter.
— 17 —
Publicité
