Publicité
Troubleshooting Guide
PROBLEM
Water droplets drip on the
fabric during ironing.
Water droplets drip from the
soleplate after the iron has
been unplugged or has been
stored.
The iron produces little or no
steam.
Flakes and white impurities
come out during ironing.
The spray function or the
steam shot do not work
properly.
The LED turns permanently
on.
Subject to change without notice.
Please do not dispose of the product in the household waste at the end of its useful
life. Disposal can take place at a Braun Service Centre or at appropriate collection
points provided in your country.
DLB253492_5712710611_SI9_UI_INT.indb 11
POSSIBLE CAUSES
The water tank lid is not properly
closed.
Chemicals have been put into the
water tank.
The steam trigger is overused.
The steam regulator is set beyond
"0" level.
You have put the iron in horizontal
position with water inside the tank.
The water tank is empty.
The valve has collected too much
scale.
The iron is not hot enough to
produce steam.
The iron has limescale formations
inside the steam chamber.
The water tank is empty.
There is a problem with tempera-
ture probe.
SOLUTION
Press the water tank lid and check if it
is closed.
Never put chemicals or perfumes into
the water tank. Empty the water tank,
rinse it 2-3 times.
Wait at least a few seconds between
each use.
Set the steam regulator to "0".
Empty the water tank after ironing and
place the iron vertically on a stable
surface during the cooling down.
Refill the water tank.
Clean the valve.
Wait until the iron heats up and the
temperature control LED is
permanently on.
Run the descaling procedure (clean
the steam chamber and the valve).
Refill the water tank.
Unplug and plug in again. If the
problem does not disappear contact
the Braun customer service.
11
06.12.16 11:23
Publicité
