Publicité
Installation instructions
Install the backrest.
Install the corner cover strips.
Panorama only: Assemble the protection grille.
3.10. Installing the electrical equipment
You need a hole in the cable shaft behind the heater measuring Ø 2 cm for the
heater supply cable. Drill the cable outlet into the right-hand corner and lay the
cable (depending on sauna control: cable runs as far as inner roof or to the
controller). Drill the cable outlet into the right-hand corner for the heater sen-
sor - Ø 1 cm. If necessary, repeat this for the bench sensor diagonally opposite
the heater sensor. Use the cable duct in the partition for the sauna control and
control panel, respectively.
Observe the operating instructions for your sauna heater and the sauna
control.
3.11. Installing the exterior decor
Assemble the ventilation grille.
Mount the exterior decor elements with 15 screws each, starting with D1 on the
wall element W1. Take care that the decor is mounted flush with the corner of
the cabin.
Fit the door panel on the outside.
Fit the window panel on the outside.
3.12. Assembly of interior door
Mount the two door fittings on the glass door, making sure that the fittings are
aligned straight and that the door opens into the vestibule.
The lower hole in the door handle is 92.4 cm high.
The fittings are aligned by adjusting/rotating the two plastic inserts.
The door handles of the glass door are screwed together from the sauna side.
Installation of door magnet and push plate.
3.13. Installing accessories
Position the floor grid.
You need a hole measuring Ø 1 cm in the cable shaft in a corner for the sauna
lamp supply cable. Drill the cable outlet into the right-hand corner and lay the
cable as far as the sauna control.
Installing the sauna lamp and lamp protection grille.
p. 16/41
Publicité
