Publicité
Installation instructions
3.5. Installation of the partition
Mounting the "mounting strip at the front" and the "post with groove for glass"
opposite the partition.
Mount the "upright with multiclips" on the wall element W19.
Place the aluminum U-profile flush onto the glass element and insert the glass
element into the groove provided. Fixing with the "element above the door" and
by inserting the "spacer bar".
3.6. Installing the interior roof
Install the roof support slats. Pay attention to the cut-outs for the cable ducts.
Put the roof elements in place, and screw them down. Pay attention to the position
of the roof elements with inspection opening and cable outlet.
3.7. Installing the outer roof
Install the rafter supports at the front and back. Pay attention to the cut-outs for
the cable ducts.
Install the roof rafters and roof panels. The roofing felt included in the scope of
delivery serves as an initial roofing. We also recommend covering the roof with
bitumen shingles, sheet metal or a suitable foil.
Insert the stainless steel ventilation grille.
3.8. Installing the windows and door
Window: Install the "mounting rails for windows" flush with the inner edge. Insert
the window from outside and screw it to the mounting rail from the inside. Fit the
"Window frame, inner".
Outer door: Install the door handle set.
Install the "mounting rail for door" flush with the inner edge.
Place the outer door in the door opening and screw it to the mounting rail from
inside.
Fit the "Door frame, inner".
The "Window frame, outer" and "Door frame, outer" are installed after
fitting the exterior decor.
3.9. Installing interior fittings
Install the two ventilation slides and skirting boards.
Panorama only: Install the bench support slats.
View only: Fit the bench foot and bench support slats.
Put the upper benches in place, and screw them to each other.
Install the bench screen and insert the lower bench.
p. 15/41
EN
Publicité
