Publicité
Installation instructions
3. Assembling the cabin
ATTENTION!
Note the floor plans on Page 12-13 as well as the assembly illustrations
starting on page 17 (following the last language of the instructions).
3.1. Installing the floor frame outside
Place the impregnated base frame on the foundation as shown on the floor plan
and the foundation illustrations (see pages 12-13). Screw the floor frames using
5 x 70 mm screws.
3.2. Assembling the inner floor frame
Place the impregnated floor frame in the cabin and screw it to the base frame.
Note the placement of the cable and the positioning of the short floor timbers
(600/342x80x40 cm) for reinforcing the surfaces where the heater stands.
3.3. Assembling the cabin walls
Start assembly by screwing the wall elements W1 and W2 to the corner post.
Check for right angles when screwing the corners together (see note on
page 4).
Pay attention to how the electrical element and the ventilation element are
positioned. The remaining wall elements are connected and screwed together.
NEVER hit the groove directly with a hammer - position a wooden strip
in between!
Install the mounting rail from below between the wall elements W2 and W4 and
place wall element W3-b on top. Repeat this step later with wall elements W15,
W17 and W16-b.
For the partition, mount the "rear mounting strip" and the wall element W19
centrally over the floor frame.
Then be sure to lay the floor!
3.4. Installing the floor
Start with the floor board in the interior door and lay the other floor boards from
there. Screw them to the floor frame after each row. Make sure the boards are
consistently parallel. The final board may need to be cut to the correct size.
p. 14/41
Publicité
