Publicité
Problem
Poor picture quality when using a
device connected to the NTSC(coaxial)
connector
Nothing appears on my TV
Possible Solution
Ensure TV is selected as the input source in the Input Select
1
menu. See "Input Select" on page 26 for more information.
Press Menu button on the remote control, select Setup, and
2
then select Channel Setup. This resets the channels on your TV.
Check the aspect ratio settings in the TV Menu. Press the Menu
3
button on the remote control and select Size. For more
information on using the TV Menu, see "Using the TV Menu"
on page 25.
Reset the original factory defaults. Press Menu button on the
4
remote control, select Setup, and then select Factory Reset.
Adjust the color temperature. Press Menu button on the remote
5
control, select Picture Settings, and then select Color
Temperature.
The problem may be with your device, contact your service
6
provider.
Ensure the TV is turned on.
1
Verify that all the cables are properly connected to the TV,
2
including the power cable.
Check to see if there is a blue or amber light on the lower,
3
right-hand corner of the TV. A blue light indicates the TV is on.
An amber light, means the TV is in power save mode.
Ensure the proper source is selected in the Input Select menu.
4
See "Input Select" on page 26 for more information.
Reconnect any devices that are currently connected to the TV. If
5
you are using multiple devices, connect and test one device at a
time.
Connect another device that you know is working properly.
6
Reset the original factory defaults. Press Menu button on the
7
remote control, select Setup, and then select Factory Reset.
Troubleshooting Your TV
37
Publicité
