Publicité
Attaching the repair device
Insert the ball joint of the repair device
corresponding recess of the fixing clamp
Fix the repair device
fastening screw
Tightening the retaining screws
for holding the supporting rod
Turn the locking screws
clips
properly.
18
Push the fixing clamp
the desired height and tighten the fastening screw
clockwise.
Mounting the magnifying glass
Insert the ball joint
and tighten the fastening screw
clockwise (Fig. A).
Push the fixing clamp
set the desired height. Tighten the fastening screw
turning it clockwise.
Placement of the base (Figure D)
The soldering iron holder
right or left side on base
cluded) as an option for left or right-handed user.
in place by tightening the
15
clockwise.
16
tightly for fixing the Alligator
23
onto the mounting rod
11
into the corresponding recess
5
on to the mounting rod
7
could be installed on either
13
with screwdriver (not in-
14
into the
15
.
11
in clockwise direction
17
properly.
22
for the ball joint
6
, set
10
12
5
and
10
by
8
GB/IE/NI
13
Publicité
